I did try to remove the SD card and launch, to reformat the SD card and launch, to ping the board... nothing worked...
I'm gonna try the update...
At least the SD Card port works, as i noticed that the m4 folder has been recreated and the update process worked... (well i think)...
Hmmm, I think one of my M4's has just done the same thing as remax's board.
I was using it fine, then switched it to another CPC. Switched it back and no M4 ROM.
I checked my connections and tried again, same thing.
All LEDs on the board flash like normal, but no M4 ROM.
I tried my other M4 on the same computer with the same connector and all fine.
So back to the other one again, I tried to access it via the webserver (SD / config file was already setup) but no connection to the webserver.
I had already upgraded to FW v1.1.0 beta 3 so I place the v1.0.9 files on the root of the SD and booted it.
You can see the LED's stay on just like expected with a FW upgrade, but once finished the CPC just sits there at the normal BASIC prompt.
I tried no SD card... just boots like a normal CPC (same as when the SD card is in).
I tried another SD (although the original reads fine in the PC and other M4).
It creates the m4 directory with the ROM files correctly.
I'm out of idea's. Is there any way I can perform a disaster recovery and get the M4 ROM back.
I'm assuming without the M4 ROM the webserver will not work as it will not get an IP.
So it appears to me that everything on the board is working (going by the LED's) it's just that somehow the M4 ROM has gone missing.
Also due to the fact when I plugged in a new / blank sd card it created the m4 directory with the ROM files.
My setup is simply a 464 with the M4 straight into it via a short ribbon cable / edge connector setup.
I have an MX4 board but that is setup on a 6128 and I have not even tried the M4 on that yet.
Cheers,
Shane