Mid sized cpc 464 board tape/power/led connector pinout

[CraigsBar]

I have replaced the power socket and completed a track repair for Shaun. However I cannot test it as I cannot find a pinout for the tape/power/led connector to power it on.

Any ideas, is it the same as the cost down?

Sent from my ONEPLUS 3t using Tapatalk

[Audronic]

@CraigsBar


I think the info you require is in the Amendment Service Manual.
I think its Page 9


Ray

[CraigsBar]

@CraigsBar


I think the info you require is in the Amendment Service Manual.
I think its Page 9


Ray

Hmmm that references the power switch on the tape board. Does this mean I cannot jumper it since I only have the cpc464 pcb.

Sent from my ONEPLUS 3t using Tapatalk

[Bryce]

The pin nearest the back of the CPC needs to be shorted with the 3rd from the back to power the 464. They are quite obvious because the tracks to these pins are much wider. Try not to let the bridge touch the pin between otherwise sparks may fly

Bryce.

[Audronic]

Info in screen Dump

[CraigsBar]

Info in screen Dump

Thanks muchly


Sent from my ONEPLUS 3t using Tapatalk