Reset Switch on a 6128+

[Manu]

Hi,

I finally installed a HxC drive in my 6128+, and I also made a cable to watch the computer in my VGA monitor using a cheap RGB to VGA converter. Right now I'm trying to install a reset switch, using this guide:

Reset Button - CPCWiki

But I've found that the reset isn't very reliable on the reset pin. Sometimes the sistem resets, sometimes it freezes. When I boot Burning Rubber, and I try to reset, some bars appear on the screen and the computer freezes.

Is there a reliable instalation on this computer?

Thanks

[MacDeath]

Not sure if relevant.Peripheral Soft Reset - CPCWiki


Perhaps you should check your connectic or the quality of the button you used?


Sorry, could mostly find french sources...

few stuffs at Amstrad today.
Amstrad TODAY
search the "resurection" part.

[TFM]

Does your switch have a problem? Get a better one! Because if it has two times contact in a short time it can screw up things.

On my plus I soldered two wires on two pins of the expansion port (in the keyboard) and made a tip-switch at the backside, it always worked fine.

[Manu]

I bought fast switches... almost 3€ a piece But maybe that's the problem.