News:

Printed Amstrad Addict magazine announced, check it out here!

Main Menu
avatar_trabitboy

strange "cable holder" when unmounting 6128

Started by trabitboy, 09:21, 01 September 14

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

trabitboy

Hello,
I'm currently unmounting my cpc 6128 motherboard to send it to Bryce for a repair;
most of it is straight forward,
however there is some sort of "cable holder"  that holds the floppy cable,
floppy power, and the cable that goes to the volume nob.


It is soldered to the motherboard ( !!! ), see pics from above and below.


It doesn't seem to do anything functional,
but I'm a bit afraid of cutting it , I thought I would ask around here first  ???




CraigsBar

On my 6128's this is just a bendy cable tie. There is no need to cut it, just bend it and free the wires.
IRC:  #Retro4All on Freenode

Bryce

Why do anything with it? The floppy cable and power cable are also soldered to the PCB, so you are going to have to send me the PCB with both of them still attached.

Bryce.

trabitboy


It crossed my mind but,There is 2 outgoing cables from the mobo,
and one from a peripheral that is blocked in there ( ingoing )
I will check again tonight  :)

Bryce

Here's what needs to be disconnected:

Floppy cables (flat and power) = Disconnect at disk end.
Keyboard = Disconnect at mainboard side
12V input = Disconnect at mainboard side
Power switch = Disconnect at mainboard side
LED = Disconnect at mainboard side

Then the PCB is free, but will still have the two cables to the floppy dangling from one end. The wire loop you mention is only soldered at one end, you can bend it up to free the wires.

Bryce.

Powered by SMFPacks Menu Editor Mod