Author Topic: CSW2CDT : hints and clever commands :)  (Read 263 times)

0 Members and 1 Guest are viewing this topic.

Offline dlfrsilver

  • CPC6128
  • ****
  • Posts: 241
  • Liked: 59
CSW2CDT : hints and clever commands :)
« on: 17:56, 18 June 17 »
Here are a few tricks when you're using the new great CDT tool made by CNGSOFT :


1) when you have a dump quite dirty, with glued blocks, please use in the extra flag prompt the command :


-t 80


In most cases, this will seperate and clean up the glued blocks.


You can do also this :


-t 80 -5


This is going to make the blocks clean with 8 trailer bytes. It doesn't work however for all schemes.


2) Beware when you process a speedlock game :


Always check the baud rate ! If the baud rate is 1900 bauds, then please apply the speedlock v4 switch, if it is 1600 bauds, it's a speedlock v6.


Be carefull when you make CDTs :)


3) Latest CPC speedlocks use either Spectrum Variant 2 scheme for the data blocks (levels).


It applies to terminator 2, Simpsons, WWF, Operation wolf and thunderbolt, Batman the movie, etc etc.