News:

Printed Amstrad Addict magazine announced, check it out here!

Main Menu
avatar_ComSoft6128

OSSC/Hauppauge Rocket problem

Started by ComSoft6128, 08:27, 07 April 19

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

ComSoft6128

Generally I can say that the above combination works well with the CPC in Mode 2.
But, and there always is a but of some kind.
Sync and therefore picture is often lost for a few seconds when loading from disc. This means that the Rocket stops recording. Is there any way to boost the signal strength (a device?) to stop this happening?

Now I'm in a hardware area that I know very little about, so all I tell you at the moment is that the output from the OSSC is accepted by the Rocket and saved as an MP4 file.

Any ideas?

Thanks,

Peter

Poliander

As far as I can tell this is not a problem with your capture card, the OSSC just takes a moment to regain sync after the screen goes completely black.
Schneider CPC 664 • X-MEM • Vortex F1-X Drive • CTM 644 • DMP 2160
Schneider CPC 6128 • Z-MEM • M4 Board • MultiPlay + Amiga Mouse • OSSC

ComSoft6128


Thanks Poliander,

I agree that the "problem" lies with the OSSC. Loading a small BASIC graphic display file is usually fine. The momentary loss (1 second?) of sync is does not cause the Rocket to stop recording.
Larger 17K screen files (especially when loading slowly from drive B) are problematic. Sometimes OK sometimes not.

Cheers,

Peter

Powered by SMFPacks Menu Editor Mod