Hi!
Recently I bought a 3.5" floppy drive B for my good CPC, but it has the Ready signal constantly set ON, which is a real pain for the software I use. I can see that because the two last wires on the flat cable are soldered to each other.
The floppy is an Alps DF354H168G drive. I couldn't find any data sheet in the net.
How can I activate it's Ready signal? Does it have one at all?
Any help is appreciated.
Can you post a decent picture of the floppies PCB?
Bryce.
*floppy's :p
I do hardware, languages are software - Not my strong point :D
Bryce.
Was just joking after you corrected me on the "what seller" thing :D
I know :)
Back to topic.... Where's the picture? :)
Bryce.
Can't get it from cell to pc... must find other solution...
?? Bluetooth, Serial, USB?? (or are you lumbered with an iPhone?)
Bryce.
Hm, email???
Use your MiniBooster! :P