General Category > Amstrad CPC hardware

FlashGordon - new batch

<< < (2/16) > >>

IanS:

--- Quote from: PulkoMandy on 20:33, 13 November 17 ---While I'm at it I'm reworking the board a little. No new features, but re-did the routing using smaller SMD components and added some silkscreen art :)


The board is slightly smaller (43mm - about the same as Albireo) and should be easier to assemble.

--- End quote ---
Has it now got chips on both sides of the board, or have you changed the design?

Audronic:
@PulkoMandy


Put me on the list for 1 (One)


Thanks


Ray

PulkoMandy:
Yes, there are chips on the back of the board in this new routing. The design/schematics is the same as the previous version (what did you think? That I found a magic way to do the whole decoding logic with just two chips? that would be too easy!)

Bryce:
You should try to keep all components on one side so that oven reflow soldering is possible. It will save you a lot of time. You could even go with an SMD socket for the flash chip, then you'd have even less to solder by hand.

Bryce.

PulkoMandy:
It will not save me any time because I don't have the required hardware. If someone wants to do this, they can make their own routing :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version
Powered by SMFPacks Reactions Mod
Powered by SMFPacks Alerts Pro Mod
Powered by SMFPacks Mentions Pro Mod