News:

Printed Amstrad Addict magazine announced, check it out here!

Main Menu
avatar_francouai

Internal ribbon cable for CPC+

Started by francouai, 08:03, 24 July 16

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

francouai

Quote from: dxs on 23:24, 17 April 17
Just bend the pin on the left of the cut-one (that's number 6) on the male connector, so that it will go inside number 4 pin of the female connector. Obviously the connector will no longer fully seat in, but if you bend the pin well enough the connection will be fine.
Then use only one jumper and place it as shown on picture.
This allows using the DS0 signal (pin 4) to select the HXC, instead of the Motor ON signal (pin 8 ), the result being that now your HXC is only selected with ùA and not with ùB.

looks like ZAXON did some update on his Gotek clone.

all of them are in except PIN 22.
see the PIN here:

--
francois

Tolkin

#76
Hy, i get the actual Zaxon Gotek with an OLED Display. Same Problem with a/b here. Have to cut Trace from Pin8 to Jumper an solder a Cable from Pin 4 to Jumper to get B-Drive working right.

Powered by SMFPacks Menu Editor Mod