ULIfAC:Usb Mass storage,WiFi, 512KB Ram/32XROM Board/256K Ram+16X Rom Board!

[Vitop69]

hello guys, sorry for my ignorance.
I bought an ESP8266-esp07 for my ulifac.
I followed john's manual by powering the ulifac with 5v, eliminated the jump and the wifi module lights up with a fixed red LED and a flashing blue one.
but I can't communicate with it either from the terminal with at+comand or from my pc with john's utility using rsx command wf,1 etc etc.
I have a doubt, do I have to flash the wifi module with a firmware to use it or am I doing something wrong?
Thanks for your support.

[Vitop69]

hello guys, sorry for my ignorance.
I bought an ESP8266-esp07 for my ulifac.
I followed john's manual by powering the ulifac with 5v, eliminated the jump and the wifi module lights up with a fixed red LED and a flashing blue one.
but I can't communicate with it either from the terminal with at+comand or from my pc with john's utility using rsx command wf,1 etc etc.
I have a doubt, do I have to flash the wifi module with a firmware to use it or am I doing something wrong?
Thanks for your support.

I report you my configuration from stat rsx command
Serial Port Speed: 921600
Interface ROM  Number: 5
Direct Mode:OFF
765 FDC Emulation:OFF
USB Device Enable: OFF (Auto:No)
DOS Emulation: AMSDOS

After WF,1 rsx command
Insert the right parametr for ssid, pwd, tcp hosting IP, and 1300 for port but I do not recive any message it's remain in stand by.

[ikonsgr]

hello guys, sorry for my ignorance.
I bought an ESP8266-esp07 for my ulifac.
I followed john's manual by powering the ulifac with 5v, eliminated the jump and the wifi module lights up with a fixed red LED and a flashing blue one.
but I can't communicate with it either from the terminal with at+comand or from my pc with john's utility using rsx command wf,1 etc etc.
I have a doubt, do I have to flash the wifi module with a firmware to use it or am I doing something wrong?
Thanks for your support.

Afaik, there is no need to update ESP module firmware,  also did you use the correct windows utility (rev.2): https://www.dropbox.com/scl/fi/93ta0tbkyhzx89cvenjgm/AmstradUtilityII.exe?rlkey=yi0iq04dz45w98jl71j7bq64d&dl=0
Mind also that you need to set the port number into windows utility too. And i suppose you use the 4pin female port for wifi module, right?

Btw, i suggest to continue to this thread which is for tech support and problems:
https://www.cpcwiki.eu/forum/hardware-related/usifac-ii-technical-problems-support/