Printed Amstrad Addict magazine announced, check it out here!
Started by ikonsgr, 08:17, 01 December 20
0 Members and 1 Guest are viewing this topic.
Quote from: Audronic on 02:12, 20 August 22@ikonsgr Is it possible the have the USB enabled at power up ?ThanksKeep SafeRay
Quote from: Audronic on 02:27, 30 August 22Is it possible the have the USB enabled at power up ?ThanksKeep SafeRay
Quote from: ikonsgr on 18:34, 05 September 22Finally the revelation came out! I've also uploaded a new firmware (6f) that gives proper boot messages, and a bit better cooperation with the new RAM/ROM board.(btw,i can't modify the 1st post to add the new firmware link... )
Quote from: vasilisk on 10:38, 16 October 22Is there a link for the updated "filemanager" ?
Quote from: kolleykibber on 16:08, 26 March 21Hi @ikonsgr I continue on my investigations with your interesting piece of kit!I've bought a few ESP-07s and have tried them on the board. But if I call |WIFI I get 'NO WiFi module detected!'.I have a cpc6128, the ESP-07s are switched to UART (I tried program too!).I've tried |USB on and off, before I call |WIFI. I've used the ESP-07 reset switch, before the RSX.If I call |WIFI a second time the system crashes.The ESP-07 is connected correctly (GND to GND) and the lights come on and you can hear the wifi signal pulsing through the CPC's speaker.I've tried different ESP-07sAm I doing something wrong?Thanks!
Quote from: WacKEDmaN on 03:42, 24 October 22i used an ESP8266 NODEMCU dev board...(eg ESP12-E)...but ANY ESP8266 will work... did yas upload the required firmware to the ESP? afaik its not the standard serial to wifi bridge like in arduino ide...i needed to download the flash tool and upload the firmware file manually.... both the flash tool and the firmware are on the dropbox page in a file called ESP8266_Flasher.zip https://www.dropbox.com/sh/ezzga2dppm6jlm7/AACwFC_rv2QatWh_ndKc9fhma?dl=0
Quote from: WacKEDmaN on 09:41, 24 October 22the ESP8622 IDF AT Bin is universal... it works on all esp8266 modules...its this AT command firmware that is required...the HS06F014 ESP-01S.bin that is included in the zip/link above is exactly that... just an older version than whats currently on the ESP site.......see if you can connect to the esp8266 via serial... (eg after you flash connect to the serial port)send 'AT' commandif it doesnt return 'OK' then youve done something wrong...(or you havent got the right baudrate)this firmware is set for 115200bps (or possibly one of the other lower rate i cant remember) you NEED to disable USB stick, and then change the baudrate on the USIFAC to match the esp8266s baudrate before giving the |wifi command... (usb sets the rate to 1mbit... which is NOT going to work with ESP8266.. max stable is 115200)if my CPC was working..id do a step by step guide...from flashing to accessing files on a PC from the CPC...
Page created in 0.171 seconds with 22 queries.