CPCWiki forum

General Category => Other retro => Classifieds => Topic started by: Vyper68 on 13:48, 14 August 18

Title: CPC M4 Connectors
Post by: Vyper68 on 13:48, 14 August 18
Hi
I ordered some expansion boards from HK with the aim to build one for myself ( these are Lambda's open source board ) and after my own board i have some left over - I have the parts to make another 3 Connectors and there will be 6 spare boards after that. I am based in the UK so postage in the UK will be £1.10 for a bare board and £2.50 for a completed board. Posting to the EU will probably be around £6-7 Airmail.
A completed board would be £10 and the PCB's would be £5 ( if you buy more than one the following boards are £2 each ).
Anyone interested just PM me.
(https://thumb.ibb.co/k88BRU/P8140024.jpg) (https://ibb.co/k88BRU) (https://thumb.ibb.co/e5cXY9/P8140027.jpg) (https://ibb.co/e5cXY9)

Title: Re: CPC M4 Connectors
Post by: LambdaMikel on 18:22, 14 August 18
Nice to see you made one for yourself!  :)
At some point I wanted to widen the traces a bit, like I did for LambdaBoard.
Even though they are short and never gave me any problems with any extension,
it would be good if there was a bit more copper and track width, especially for GND and VCC.
Title: Re: CPC M4 Connectors
Post by: Vyper68 on 20:17, 14 August 18
You don't mind me selling my spares do you Lambda? - I don't want to upset the apple cart.
Title: Re: CPC M4 Connectors
Post by: Vyper68 on 20:20, 14 August 18
Nice to see you made one for yourself!  :)
At some point I wanted to widen the traces a bit, like I did for LambdaBoard.
Even though they are short and never gave me any problems with any extension,
it would be good if there was a bit more copper and track width, especially for GND and VCC.
It sounds like it would be a good improvement to a nice little board. I just need one for a M4 and RAM expansion on the back.