Started by ngtwolf, 23:26, 26 May 19
0 Members and 1 Guest are viewing this topic.
Quote from: ngtwolf on 00:53, 27 May 19How does it know that it's drive B?
Quote from: pelrun on 06:35, 27 May 19Jumpers aren't needed because it's essentially hard-coded cable select, with only one drive select signal available on each connector.The external connector has an inverted /DRV1 signal to the internal one, so when the internal drive is selected the external is disabled and vice versa.
Quote from: pelrun on 08:44, 27 May 19Ok, looking at the service manual, there actually *is* a drive select jumper SW1/JP119, it's a wire link instead of a header with a removable jumper. Changing that seems a lot easier than monkeying with the cable.Found a decent photo here: http://www.cpcwiki.eu/forum/hardware-related/fixing-floppy-drives/msg144099/#msg144099
Page created in 0.084 seconds with 36 queries.