Wiring for a PCW9512 motherboard

Started by handyandy69, 11:06, 19 September 19

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

handyandy69

Hi,

Starting a project to fit a PCW9512 motherboard in to an old server case with power supply.  Just wondered if someone could confirm the voltages on the Yellow, Red & Orange wires attached to the power connector.  I'm assuming the 2 black wires are ground (Unless Alan had run out of different coloured wires that day)

Cheers,


Andy.

Bki

Yes
1/ black gnd
2/ black gnd
3/ red 5v
4/ orange 12v
5/ yellow  24v (only used for the printer output)

You can easily check it . On the CPU motherbord, the power wires are labeled on the PCB (5v) (12v) with the same colours and using a tester, from red (floppy power)  to midle (power input) = continuity

Bki

And remember than if you want to use 3,5" floppy drive, you have to swap the red and orange wires on this floppy power cord. The original floppy wiring is only for 3" floppy drive

Powered by SMFPacks Menu Editor Mod