50 pin edge connector with long legs

[protek]

I have a slightly damaged cartridge connector in my SVI-728.
[attach=2]

I've desoldered the old connector but the replacement that I have has significantly shorter legs than the original.
[attach=3]

Anyone know a place to source a suitable replacement or a way to fabricate a riser?

[CraigsBar]

I probly have one you can have. How long do you need the legs? As the pictures do not load on my phone.

[protek]

The legs need to be 12 mm, so rather long ones.

[Bryce]

It depends on the height of the plastic too. The height you need to check is from the top surface of the connector to the bottom of the pins.

Bryce.

[CraigsBar]

Will this do?


The Legs are 13mm


It looks a bit battered, it was a sod to desolder! but all pins are intact and contact is good.


PM me your address and I'll get it in the post.

[protek]

Will this do?


The Legs are 13mm


It looks a bit battered, it was a sod to desolder! but all pins are intact and contact is good.


PM me your address and I'll get it in the post.

Looks perfect. PM on its way. 

[protek]

Thanks to generosity of GraigsBar, the 728 has now a new module port and games are working perfectly. 

[attach=2] [attach=3]

[CraigsBar]

Thanks to generosity of GraigsBar, the 728 has now a new module port and games are working perfectly. 

[attach=2] [attach=3]

awww shucks.... just happy to have helped.