General Category > Technical Support

464 Plus and CTM644

(1/2) > >>

berneslai:
Apologies for the noob question.  I've picked up a 464 Plus today that was thrown in as an afterthought as part of a wider bundle with some Atari STs.  The unit is bare with no leads and I'd prefer not to start investing in cables for a system that could be beyond repair.  I already own a 464 and CTM644 monitor - are there any conversion kits so I can using the existing hardware that I own to test the 464 Plus unit?

pelrun:
All you need is a simple adapter cable with a 6-pin female DIN on one end and an 8-pin male DIN on the other, wired using the pinouts from https://www.cpcwiki.eu/index.php/Connector:Monitor . It should also take the 5V power from the monitor as well, although you might need a 2.1->2.5 DC jack adapter in between. I'm using this setup with a GX4000 and it works perfectly.

berneslai:
Thanks pelrun.  Does anyone offer these for sale before I try not to burn my house down with the cheap soldering iron that I have?

dragon:
http://retrocables.es/tienda/index.php?id_product=101&controller=product&id_lang=1


About 5v wire ctm 644 better send they a email.


http://retrocables.es/tienda/index.php?id_product=1418&controller=product&id_lang=1

eto:

--- Quote from: berneslai on 15:55, 19 September 21 ---Thanks pelrun.  Does anyone offer these for sale before I try not to burn my house down with the cheap soldering iron that I have?

--- End quote ---

I'm using this one: https://www.ebay.co.uk/itm/322252720311

Navigation

[0] Message Index

[#] Next page

Go to full version
Powered by SMFPacks Reactions Mod
Powered by SMFPacks Alerts Pro Mod
Powered by SMFPacks Mentions Pro Mod