CPCWiki forum

General Category => Technical Support - General => Topic started by: JPas2001 on 10:08, 25 July 21

Title: 6 pin cord Cut CTM 644
Post by: JPas2001 on 10:08, 25 July 21
Hello there !
First of all sorry for my bad English, hope you'll understand my problem.

I got the 6 pin cord Cut of my CTM 644 monitor. I want to replace this, but i dont found the colour code.

I got red, green , blue , yellow, black , white and brown cable. I don't know with which pin must be soldered.

Someone have this information ?

Thanks in advance.

JPas
Title: Re: 6 pin cord Cut CTM 644
Post by: SkulleateR on 13:13, 28 July 21
I once changed the DIN connector on my CTM640 but basically it should have the same wire setup ... only thing is, I had no white wire but maybe I just forgot to write it down ....


Anyway (use at your own risk) :


Solder Side DIN
Pin 1 -> red (R)
Pin 2 -> green (G)
Pin 3 -> blue (B)
Pin 4 -> yellow (HSYNC)
Pin 5 -> black (GROUND)


so I still don't have a clue about white and brown, one should be luminance I guess .... maybe someone can fill the missing wire connections here ?
Powered by SMFPacks Menu Editor Mod