A repair mod for the tape counter reset button

[geebus]

Yeah, with something that small it's probably irrelevant, but I was printing something this week that took about 11 hours at 0.2mm. At 0.05mm it would take over 44 hours!!

Bryce.

Yeah I have done a few prints that Have taken a fair amount of time. It just depends on the end result you want though.
There is a noticeable difference in the quality when I change it to slice that low, so if I want the quality and being hardly able to tell that it's 3d printed then thats what I shall do.
If speed is the key and i'm not to worried about the quality as much, i'll up it to .1 or .2. Anything highers is just SOO bad that whatever it was, is not whats being printed  .

[Bryce]

The model had critical dimensions and moving parts, so I cancelled at about 20% when I saw it wasn't going to work. Now I need to find a time where it can print at 0.1mm for about 24 hours.

Bryce.

[Grega]

is there an STL for this?
if so can someone share it i have 2 x 3D printers (here in AU)
ray i'll print you a heap mate no issue (its greg from friday)
and anyone else who wants one.

[Audronic]

@Grega


Thanks Greg. Thats excellent.
I would only want 1 at the moment.


Appreciated.   Ray

[Audronic]

@Grega


I have sent you a Personal Message.
If you get a chance could you contact me.


Thanks.  Ray

[Grega]

Ray, just PM'd you buddy

[Audronic]

Hi Greg


I just found this one


Can you PM me your email address Please or Phone number ?


Ray

[Audronic]

Hi All


Thanks for your replys
I am all sorted now.
I don't require any replacement buttons.
Thanks for all your help


Keep Safe (Victoria Australia)


Ray

[geebus]

Did the prints I sent work ok? I never had a chance to test one before sending them off as I never had any broken on my machines.

[Audronic]

@geebus


when the buttons arrived I no longer had the CPC464's
I passed the buttons on to an other member.
Next time I contact him I will ask how they went.
Thanks for all your work


Keep Safe


Ray