General Category > Technical Support

CPC464 Display issue

(1/2) > >>

pusb:
Hi,
I've just bought a CPC464 with a faulty display. Seller thought it was the cables from the monitor that were the problem. The screen is all smeared and flickering.


Moving the cables does change the flickering, but still not to the point of it being visible




Is there anything obvious I can try before spending money on a new monitor?

Duke:
I think the seller is correct and the cable has some damage. Probably you could cut the cable and solder on a new DIN plug.

Bryce:
The sync signal isn't getting to the monitors PCB. Either a break in the cable, dirty contacts or the connector inside is loose.

Bryce.

pusb:
Thanks guys just wanted to make sure it is the monitor rather than a console issue

Bryce:
Definitely not a problem with the computer.

Bryce.

Navigation

[0] Message Index

[#] Next page

Go to full version
Powered by SMFPacks Media Embedder
Powered by SMFPacks Alerts Pro Mod
Powered by SMFPacks Mentions Pro Mod