Started by eto, 10:34, 10 February 22
0 Members and 1 Guest are viewing this topic.
Quote from: Nworc on 23:12, 10 February 22The Eprom programmer is the expensive part of the fun. I have an old Batronix Galep, the software is quite good. The company still exists and they are still doing the programmer, but I guess you don't want to pay 500 euros just for the little fun to burn something. I hope someone else comes up with a recommendation - otherwise you can check the internet auctions from time to time to look for a used one, or try one of the cheaper chinese copies. Buying chinese material means that you know how to repair and improve stuff, as this is the first thing you do when it arrives. If you can do that, you can save some money, and I still have a lot of fun with the chinese desoldering station from Zhongdi, it goes suck suck suck and there it goes, a fearsome beast with 44 legs. Okay, I lost the track a little.Erasing: buying an eraser is the best thing you can do, as UVC light makes you blind. If you don't fear that, you can build a box with a switch that turns off the lamp when you open it, and be using a Philips TUV 4W/G4 T5 lamp inside. This lamp is normally used to clean the water for e.g. aquariums, but is perfect for this job. But building that box is more expensive than buying one, so forget it. In that internet auction site look for Eprom UV Timer, the one with the aluminum body is a good one.Welcome to the club. Let's burn!
Page created in 0.143 seconds with 36 queries.