Printed Amstrad Addict magazine announced, check it out here!
Started by ||C|-|E||, 12:24, 02 May 16
0 Members and 1 Guest are viewing this topic.
Quote from: ||C|-|E|| on 12:24, 02 May 16The other day, when I added the little caps to the RGB output in my Plus some of you guys noticed that some soldering points in the board looked actually dry and it would be nice to reflow them. So, yesterday I decided to carefully go through the whole board. This is what I found.As you can see, many of the soldering points actually looked dreadful. I do not know if this happened during the wave soldering process or later, but the whole board looked far from nice (imho). It is very different from the conventional 6128 I have in Spain or the board from the CM-14, that was actually very nice. So, I proceeded to reflow most of the soldering points and the look properly wet now.[attachimg=1][attachimg=2]Since I had the board in the hand, I thought that I would change the caps that had the leads obviously bent, just because I did not really like them the way they were. [attachimg=3]And I did it. I actually changed the two big guys (470 pf) but the process, that is usually deadly simple, probed very difficult in this case. It seems that they were put in place before the wave soldering by pressing the leads to make them wider and them hard pressing them through the holes. Then, the leads were bent further to prevent any movement. Summary is that removing the caps from the board was a bloody nightmare and I only changed those two . The rest of the components seem to be placed in the board using the same method, by the way.And that was it!
Quote from: CraigsBar on 23:16, 02 May 16What rating caps.... And where do they need soldering?
Quote from: ||C|-|E|| on 23:29, 02 May 16Sorry, I don´t understand well Do you mean the caps I added to the RGB output?
Quote from: pelrun on 14:05, 02 May 16I LOVE YOU KITCHEN DESOLDERING GUN! (actually just got access to a decent one, finally I no longer have to deal with the pain of removing through-hole parts...)
Quote from: khaz on 23:50, 02 May 16I've been using this to desolder stuff:30W 220V 50Hz Electric Vacuum Solder Sucker Desoldering Pump Iron Gun DNS | eBayMost certainly not the best tool for the job, but one of the cheapest. It works fine, once you get used to how the sucking works.
Page created in 0.139 seconds with 25 queries.