Last modified on 1 October 2010, at 23:55

Schneiderware Pseudo ROM

Revision as of 23:55, 1 October 2010 by Nocash (Talk | contribs) (I/O Ports)

The Schneiderware Pseudo ROM is a expansion "ROM" board, with 16K EPROM (read-only) and 16K battery-backed SRAM (read/write-able), published by german magazine CPC Schneider International as part of their Schneiderware DIY series. The plain PCB, or the fully assembled board were also available via mail-order.

The ECB Bus connector of the board is intended to be plugged into the Schneiderware Basisplatine, but it could be also wired directly to the CPCs Expansion Port.

I/O Ports

Address (default) Usage
DFxxh Schneiderware RAM/EPROM - Expansion ROM bank number (W)
Battery-backed SRAM and/or EPROM are selected when the bank-number matches the jumper-selected values; the memory is then mapped to C000h..FFFFh (in case of READing one must also enable upper ROM via Gate Array). The bank number decoding is a bit strange:
  • EPROM/Read bank: All 8 bits decoded (bank 00h..FFh)
  • SRAM/Read bank: Only lower 4 bits decoded (bank X0h..XFh)
  • SRAM/Write bank: Only lower 4 bits decoded (bank X0h..XFh)

The SRAM/Write mode doesn't disable the internal RAM in the CPC, so writes are going both to SRAM and normal RAM at C000-FFFF, that no matter if upper ROM is enabled/disabled via Gate Array; the author recommended to map VRAM to 4000-7FFF via CRTC registers, in order to prevent video dirt during writing.

Note - Port DFxxh is the standard Upper ROM Bank Number register, which is also used by AMSDOS, for example. Reserved banks are 00h=Basic, and 07h=AMSDOS. Bank FFh (and XFh) can be also considred as reserved (as it's used by the "128K RAM detection" in CP/M+). Other bank numbers can be used by one (or more) Schneiderware Pseudo ROM board(s).



The magazine article contains three listings with examples how to use the Pseudo ROM board, including a ROM version of the Schneiderware Real Time Clock driver.

Scanned Article