Hi,
Been a while since I used me old CPC 6128 as I have a 6128+. I checked it whilst off on holiday, hooked the 6128 to my CTM 644 and the disk drive wouldn't spin up. There was a red light on the front of the drive but no noise and loading a disc resulted in a failure (retry or ignore.)
I plugged my CPC 664 into my CTM 644 and the disk drive also wouldn't spin up either.
So, it would seem it's a problem with the monitor's power output. Anyone one know if there a fix for it? I had a search around and couldn't find anyone with a similar problem.
Thanks,
Falfa
@Falfa (http://www.cpcwiki.eu/forum/index.php?action=profile;u=62)
I was wondering if you plugged in the -12 volt cable ??
Ray
Have you actually measured the 12V output to see if there's 12V there?
Bryce.
Hi, thanks for the input, yeah. I tried that, have been using it for years.
Quote from: Audronic on 13:44, 22 December 19
@Falfa (http://www.cpcwiki.eu/forum/index.php?action=profile;u=62)
I was wondering if you plugged in the -12 volt cable ??
Ray
Hi,
No I haven't. Good place to start. Will check that this weekend.
F.
Quote from: Bryce on 14:20, 22 December 19
Have you actually measured the 12V output to see if there's 12V there?
Bryce.