Print Page - Mid sized cpc 464 board tape/power/led connector pinout

Title: Mid sized cpc 464 board tape/power/led connector pinout
Post by: CraigsBar on 21:14, 14 December 17

I have replaced the power socket and completed a track repair for Shaun. However I cannot test it as I cannot find a pinout for the tape/power/led connector to power it on.

Any ideas, is it the same as the cost down?

Sent from my ONEPLUS 3t using Tapatalk

Title: Re: Mid sized cpc 464 board tape/power/led connector pinout
Post by: Audronic on 21:59, 14 December 17

@CraigsBar (http://www.cpcwiki.eu/forum/index.php?action=profile;u=482)

I think the info you require is in the Amendment Service Manual.
I think its Page 9

Ray

Title: Re: Mid sized cpc 464 board tape/power/led connector pinout
Post by: CraigsBar on 22:10, 14 December 17

Quote from: Audronic on 21:59, 14 December 17
@CraigsBar (http://www.cpcwiki.eu/forum/index.php?action=profile;u=482)

I think the info you require is in the Amendment Service Manual.
I think its Page 9

Ray

Hmmm that references the power switch on the tape board. Does this mean I cannot jumper it since I only have the cpc464 pcb.

Sent from my ONEPLUS 3t using Tapatalk

Title: Re: Mid sized cpc 464 board tape/power/led connector pinout
Post by: Bryce on 08:27, 15 December 17

The pin nearest the back of the CPC needs to be shorted with the 3rd from the back to power the 464. They are quite obvious because the tracks to these pins are much wider. Try not to let the bridge touch the pin between otherwise sparks may fly :)

Bryce.

Title: Re: Mid sized cpc 464 board tape/power/led connector pinout
Post by: Audronic on 10:08, 15 December 17

Info in screen Dump

Title: Re: Mid sized cpc 464 board tape/power/led connector pinout
Post by: CraigsBar on 21:59, 15 December 17

Quote from: Audronic on 10:08, 15 December 17
Info in screen Dump

Thanks muchly

Sent from my ONEPLUS 3t using Tapatalk

CPCWiki forum

General Category => Amstrad CPC hardware => Topic started by: CraigsBar on 21:14, 14 December 17