WinApe ROM loading question

[LatinMadness]

Hi

Just wondering how you load & run the Mirage Imager ROM in WinAPE? Doesn't appear to have an RSX. Hackit etc work fine but I can't get this to work. Do I just need to call the relevant jumpblock address..?

Thanks

[arnoldemu]

Hi

Just wondering how you load & run the Mirage Imager ROM in WinAPE? Doesn't appear to have an RSX. Hackit etc work fine but I can't get this to work. Do I just need to call the relevant jumpblock address..?

Thanks

Perhaps the hardware is special and it's not been implemented in winape?

EDIT: Yes the hardware has it's own ROM and RAM.
EDIT: The ROM contents don't appear to be normal z80 instructions, it seems it may be encrypted or scrambled or a bad dump.....?

[ralferoo]

Perhaps the hardware is special and it's not been implemented in winape?

EDIT: Yes the hardware has it's own ROM and RAM.
EDIT: The ROM contents don't appear to be normal z80 instructions, it seems it may be encrypted or scrambled or a bad dump.....?

There's no reason for the address lines and data lines to be wired up as you'd expect... Quite often people will swap these lines round if it makes a PCB easier to route.

[TFM]

So... can somebody read the ROM again using the CPC (Maxam for example)?
Then you can compare.

That aside, the MF2 is imho superior to the MI.

[arnoldemu]

So... can somebody read the ROM again using the CPC (Maxam for example)?
Then you can compare.

That aside, the MF2 is imho superior to the MI.

It is a good suggestion and I agree completely that MF2 is the best.