CPC464-6128-664 Printer Cable wiring Diagram Please

[Audronic]

Hi All

I have looked everywhere but am unable to find "CPC464-6128-664 Printer Cable wiring Diagram"
If you have a link That would be appreciated.

Thanks

Keep Safe

Ray

[wolfgang]

The printer port connections for a CPC464 are in the manual on page 238:

https://commonplace.doubleloop.net/files/cpc464.en.pdf

I think its the same for the CPC664 (edge connector) while the CPC6128 has a standard D-SUB connector (which means you should be able to use a standard Centronics cable), the standard connection of a Centronics printer you can find here:

https://www.controllersandpcs.de/pdfs/parallelport.pdf

Is that what you are looking for?

[eto]

the CPC6128 has a standard D-SUB connector

The CPC 6128 has edge connectors too, except for the German CPC 6128 which has a Centronics connector. The Plus has a D-SUB connector.

I have looked everywhere but am unable to find "CPC464-6128-664 Printer Cable wiring Diagram"

No diagram but just recently I made a Edge-to-Centronics (464 to printer) cable. Is that the one you are looking for? I can take pictures.

[Audronic]

The printer port connections for a CPC464 are in the manual on page 238:

https://commonplace.doubleloop.net/files/cpc464.en.pdf

I think its the same for the CPC664 (edge connector) while the CPC6128 has a standard D-SUB connector (which means you should be able to use a standard Centronics cable), the standard connection of a Centronics printer you can find here:

https://www.controllersandpcs.de/pdfs/parallelport.pdf

Is that what you are looking for?

Thanks for the link I will Have a look at it

Keep Safe

Ray

[Audronic]

I have looked everywhere but am unable to find "CPC464-6128-664 Printer Cable wiring Diagram"

No diagram but just recently I made a Edge-to-Centronics (464 to printer) cable. Is that the one you are looking for? I can take pictures.
 
@eto
Yes Photos would be good.
The cables i have seen have 1 Trace removed, I don't have this cable anymore, and i did not take a note of the missing trace
That is the reason for the inquiry.

Thanks

Keep Safe

Ray

[eto]

@Audronic


my printer cable does not have one pin cut as my printer has the DIP switches to avoid the additional line feed. 

If you don't have the DIP switch it probably is the 8th lane from the right (first picture) which is the autofeed signal that is put to GND in the CPC. 

[Audronic]

@eto 

Thanks for that update.
I will work out the pin number for the CPC end of the cable.

Thanks

Keep Safe

Ray