Print Page - Mounted reset switch after installing Gotek drive.

Title: Mounted reset switch after installing Gotek drive.
Post by: Bignumbas on 22:45, 06 February 17

I don't need 12v anymore.

Title: Re: Mounted reset switch after installing Gotek drive.
Post by: Skunkfish on 10:45, 07 February 17

I like it! :D

How's it wired up internally?

Title: Re: Mounted reset switch after installing Gotek drive.
Post by: Bignumbas on 12:19, 07 February 17

http://www.cpcwiki.eu/index.php/Reset_Button
I soldered to where pin 40 comes through to the top of the main board a few mm behind the top contacts.
Pin 40 is on the underside. I also used the big soldered ground point between the expansion contacts and the 12v cable entry.
I could take a photo if you want

Title: Re: Mounted reset switch after installing Gotek drive.
Post by: buzby on 00:35, 08 February 17

Photos please

Title: Re: Mounted reset switch after installing Gotek drive.
Post by: Bignumbas on 02:21, 10 February 17

Added wiring photo to original post

CPCWiki forum

General Category => Technical support - Hardware related => Topic started by: Bignumbas on 22:45, 06 February 17