Print Page - Poorly AMX mouse (PCW8512)

Title: Poorly AMX mouse (PCW8512)
Post by: JonB on 20:20, 30 December 13

Hi

I've just scored an 8256 with AMX mouse but on loading AMX desktop the mouse appears to be dead. There is no response. Is there a test program, and does anyone have any advice for me if I want to troubleshoot it?

Thanks

JonB

Title: Re: Poorly AMX mouse (PCW8512)
Post by: TFM on 00:18, 31 December 13

Check the ball of the mouse. Is the rubber still ok, or did it melt?

Title: Re: Poorly AMX mouse (PCW8512)
Post by: CanonMan on 12:36, 31 December 13

Quote from: JonB on 20:20, 30 December 13
Hi

I've just scored an 8256 with AMX mouse but on loading AMX desktop the mouse appears to be dead. There is no response. Is there a test program, and does anyone have any advice for me if I want to troubleshoot it?

Thanks

JonB

I repaired an AMX mouse for a friend a few years ago, it turned out to be the single 74-series logic chip inside the mouse that had failed. I can't remember number, off the top of my head, but if you open it up you'll probably find just that one chip and very little else!

Are you the same JonB from Stairway to Hell?

Title: Re: Poorly AMX mouse (PCW8512)
Post by: JonB on 14:06, 31 December 13

Turns out the cable was damaged in two places, so I have repaired it and it's up and running.

Thanks all!

@CanonMan: yep, 'fraid so! ;)

CPCWiki forum

General Category => NC100, NC200, PCW, PDA600 - the rest of the Family! => Topic started by: JonB on 20:20, 30 December 13