Changes

I have recently received a CPC6128 and had the problems to connect 2x3=== Preface === This document shows pinning list,5" drives to the CPC (internally and externally). The main problem was, that i've could not find detailed informations about the wireing diagrams and the signals (even here signal descriptions found on CPCWIKI.EU) This is my contribution to this issue. I will add the wireing for the DDI-1 soona CPC6128.   

==== Floppy Standard floppy connector 34pin <br> ====

connector | for standard floppy 34 pin connector 34pin

==== CPC-CD201 (internal floppy 26pin connector) ====<pre>CPC-CD201 | Signal description internal

| (numbering from amstrads Amstrads repair manual)

==== CPC-PL-9 (external floopy 34pin centronics connector) ====

| (numbering from amstrads Amstrads repair manual)

<br>

<br>

==== External floppy connector CPC-PL-9 to standard floppy connector 34pin ====<pre>External floppy connector PL-9 to standard floppy connector 34pin=================================================================

==== Internal floppy connector CD201 to standard floppy connector 34pin ====<pre>Internal floppy conntector CD201 to standard floppy connector 34pin==================================================================

01 NC</pre> 

==== Floppy drive ====

* This cables work for drive which are jumpered as drive 1 or /DS1. This is normally the default selection on drive delivery. Also make * Make sure you find a drive which has the possibility to generate a ready signal instead of a disc change signal.

If you intend think about to use a HD drive, make sure to close the HD detection hole on your disk. </pre>