Changes
/* PCW and 6128 Expansion Port 50 way edge connector */
| [[File:Marking the pins.png|thumb|1. Mark the pins on the edge connector. Drag a pencil across the pins, about 1mm above the point where the pin narrows.]]
||
| [[File:Bending the pins.png|thumb|2. Bending the pins on the edge connector. Bend one pin at atimea time, and line up the tip of the pliers with the pencil mark on each leg. Keep the pliers perpendicular to the back of the connector and move them inwardsand downwards, holding the connector firmly.]]
||
| [[File:Trial fitting to the expansion port adapter board.jpg|thumb|3. Trial fitting to the expansion port adapter board. Make adjustments here, and once all the pins are in the holes, press the board and connector together firmly.]]
| [[File:Connector sitting square.jpg|thumb|4. You are looking to ensure the connector is sitting square on the adapter board.]]
||
| [[File:Close up of solder side of the connector.jpg|thumb|5. Close up of solder side of the connector. Check that all the bent pins are showing before beginning to solder the connector to the board. If a pin is missing, check it has not folded underneath the connector.]]
|}
